When mixing high viscosity liquids, the roles of the static mixers conversion process and division process are very important.
The Conversion process shuffles the fluids of the cylinder’s wall and the center areas. The Division process separates the fluid in half. By repeating this process, the inequalities that occur in the fluid are eliminated.
Because of this, the role of a mixer does not stop at the conventional “mix A and B, but also helps to improve the inequalities related to the degree of viscosity, temperature, concentration, density, fl ow rate, stagnant time and heat history. Available are the N20 type for synthetic fi ber, the Thermo Mixer for extruders, and the Polymer Mixing Nozzle for injection molding.
|Chemical fiber spinning process use||●Improvement of the viscosity and the temperature irregularity in the distribution tube
●Dissimilar polymer blend
(Edge Seal Type)
|●Improvement of the viscosity and the temperature irregularity in the spinning nozzle
●Mixing of additive
|Extruder use||●Improvement of the viscosity and the temperature irregularity occurring in the extruder||TM series
|Injection molder use||●Improvement of the viscosity and the temperature irregularity occurring in the injection molder||PM series
<Polymer mixing nozzle>